Copyright (c) 2000-2018 by Nu2 Productions. All rights reserved.

Only HP logo and 'Serial rom v1.08 is displayed' on HP Ipaq


Created: Aug 18, 2005
Updated: Aug 18, 2005



:: Problem description [#intro]
:: Bootloader mode [#locate]
:: How to solve [#move]
:: Remarks [#done]

> Problem description


[#intro]

For some unknown reason an HP Ipaq PDA can get into a mode where it does not react to any button (including the power and reset button).
The display only gives the text 'Serial' at the top, the HP logo in the middle and the text 'Rom v 1.08' at the bottom.
This has happened to ipaqs getting exposed to high temperatures (leaving your Ipaq in your car in the sun).

> Bootloader mode


[#locate]

Your Ipaq is in a special bootloader mode. In this mode it is possible to do firmware updates without using activesync.
You can enter this mode manualy by pressing the left two buttons, the power button AND the reset button at the same time.
Be aware that entering this mode will do a hard reset on your Ipaq, loosing all your data!

> How to solve


[#move]

If your device has entered this mode for some reason you can leave it by pressing the left two buttons and the reset button. After this press the power button to turn your device back on.

> Remarks


[#done]

THIS PROCEDURE IS PROVIDED "AS IS," WITHOUT WARRANTY OF ANY KIND, USE AT YOUR OWN RISK!



Use information from this site elsewhere? Check our legal information page: http://nu2.nu/legal/
To contact the author look here: http://nu2.nu/contact/

Copyright (c) 2000-2018 by Nu2 Productions. All rights reserved.